Aqara G5 camera junction box with 48 mm height for concealing connectors and excess cable behind the camera. Compatible with the PoE and USB-C versions, with multiple cable exits and a drain hole in the base.
WHAT YOU RECEIVE
• 1 PETG junction box in white, black or grey
• Mounting screws
• Camera is not included
FIT & FINISH
INSTALLATION
Position the box and mark the wall fixing holes. Route the cables inside, then attach the G5 mount using the provided screws. For outdoor installations, seal the cap joint and cable entries with silicone as appropriate and keep the base drain hole clear. The enclosure is not supplied with a certified waterproof or IP rating.
Check your wall, fasteners and cable connections are suitable for the installation. This is a cable housing, not an electrical connection device. The camera and its own installation requirements remain separate.
🛡️ GENERAL PRODUCT SAFETY (EU 2023/988 - GSPR)
• Manufacturer / Responsible person: This shop (products are 3D-printed to order in the EU).
• Product: 3D-printed PETG junction box / cable housing accessory for the Aqara G5 camera.
• Materials: PETG plastic.
• Safety warnings: Not a toy. Keep small parts and screws away from children under 3 years (choking hazard). For outdoor use, seal with silicone as instructed to keep out moisture. This is not electrical equipment — it houses cabling only; all electrical connections must comply with local regulations and be performed by a qualified person where required. Made to order; minor variations in color and finish may occur.
• Care: Clean with a damp cloth; avoid solvents.
Color
WhiteBlackGrey
Product Safety and Contact
Artikelreferenz: 4566726604. Questions about safe use or compatibility of this item: Alto 3D Aleksandar Toshovski, Seltenbachstr. 8, 76327 Pfinztal, contact@geroite.com.
ALTO 3DFILL THE GAP
Cart 0